Great Printer
AMS and software comming along nicely
I had the power go out in the middle of a print..heat creep
and stuck filament in the nozzle..
Upon doing a cold pull the extruder has a tiny piece of filament stuck in the middle of it so I had to pull it apart also.
Sourceing a UPS big enough so this does not happen again...
I got a 900 watt UPS from Jcar but it screams every time I start a print..When the bed warms up.
Not really the printers fault when the power goes out.
After following these Directions it is now working
change the filaments not while printing
enable update on insurtion of filament
unload and remove filament ..reinsert and assign colour and type